 CV removal tool/Engine drop question, special or autozone? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| stateofidleness |
 Jan 2 2008, 11:25 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 810 Joined: 1-September 07 From: Canyon Lake, Texas! Member No.: 8,065 Region Association: None  |
i WILL have the engine out tomorrow dammit!
is there a special tool i need to remove the CV axles or can i "borrow" it from AutoZone or somethin? also, i have everything in the engine compartment disconnected and everything but the clutch cable, CV's, and the shift linkage disconnected underneath. I have the rear on ramps (should have more than enough clearance) and the front on stands the pelican how-to does theres by lowering the car all the way down (almost to the rotors).. will i need to do this or can i put the floor jack underneath the tranny and lower slowly? anything else to look out for? |
   |
 
|
Posts in this topic
stateofidleness CV removal tool/Engine drop question Jan 2 2008, 11:25 PM
MrKona I got my CV tool from Pelican. You can also get th... Jan 2 2008, 11:32 PM stateofidleness what does the tool look like? and is there an alte... Jan 2 2008, 11:37 PM
MrKona
what does the tool look like? and is there an alt... Jan 2 2008, 11:49 PM McMark They are sold at most parts stores. It's a 12... Jan 2 2008, 11:52 PM Blood red 914-6gt :rotfl: When you guys started talking about specia... Jan 2 2008, 11:57 PM banger Autozone has them, thats where I got mine. Jan 3 2008, 01:00 AM Bartlett 914
:rotfl: When you guys started talking about speci... Jan 3 2008, 12:12 PM Spoke I bought a set of the 12 point tools at my FLAPS. ... Jan 3 2008, 06:20 AM bperry The socket 12 point tool is a bit nicer but I neve... Jan 3 2008, 12:25 PM tdgray Make sure you use new crush washers and possibly n... Jan 3 2008, 12:32 PM stateofidleness got the tool at autozone and the engine is out... Jan 3 2008, 07:11 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 10th June 2024 - 02:46 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.