 Replacing center tunnel feul lines |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| dbgriffith75 |
 May 28 2008, 11:26 AM
Post
#1
|
|
TheGrif  Group: Members Posts: 509 Joined: 25-July 07 From: Iowa, USA Member No.: 7,945 Region Association: Upper MidWest  |
I've already removed the old lines so as to get them out of the way when I do the paint, and what I've done to aid in feeding the new lines is I fed light gauge wire through the old lines before removing them, then just tied bolts to each end of the wire to prevent them from falling out. It may not be the best way, but it's at least a guide.
Anyway, I'd like to know what's reccomended to do replace them with. As you can imagine the old plastic lines are frail and brittle, and I've already broken them more than once. I'd like to replace them with steel lines. But would aluminum/copper/brass be better? |
   |
 
|
Posts in this topic
dbgriffith75 Replacing center tunnel feul lines May 28 2008, 11:26 AM
plymouth37 I would go with stainless, Tangerine Racing (CFR) ... May 28 2008, 11:36 AM Vacca Rabite CFR stainless steel fuel lines are the way to go, ... May 28 2008, 11:37 AM ericread Take a look at Tangerine Racing. The basic set is... May 28 2008, 11:41 AM
dbgriffith75 Right on! Consider it DONE! May 28 2008, 01:52 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th June 2024 - 12:45 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.