 Bronze Trailing Arm Bearing |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Wilhelm |
 Jun 28 2008, 05:23 PM
Post
#1
|
|
Member  Group: Members Posts: 408 Joined: 7-September 07 From: Hooterville, OR Member No.: 8,088 Region Association: None  |
Had some time and bronze extrusion so thought I would try my hand at making some trailing arm bearings. Hopefully these will eliminate the "striction" (sticky friction of synthetic bearings). The ID is 28mm, the OD is 38mm, the flange diameter is 52mm, the flange width is 6.3mm, the overall length is 55mm. To do list: cut an oil groove midlength and crossdrill into this. After pressing these in will drill and thread a grease zerk to intersect the oil groove.
|
   |
 
|
Posts in this topic
Wilhelm Bronze Trailing Arm Bearing Jun 28 2008, 05:23 PM
Racer Chris My Delrin bushings don't have "striction... Jun 28 2008, 05:39 PM
Wilhelm
My Delrin bushings don't have "striction... Jun 28 2008, 07:48 PM So.Cal.914
My Delrin bushings don't have "strictio... Jun 28 2008, 08:59 PM Wilhelm
Attachments are working now.
Don't know ... Jun 28 2008, 07:39 PM J P Stein Some things you should be aware of:
The ID of the... Jun 28 2008, 09:50 PM Wilhelm
Some things you should be aware of:
The ID of th... Jun 28 2008, 10:23 PM r_towle Two hardened washers per side with a thrust bearin... Jun 28 2008, 10:31 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 11:18 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.