 Washer for ball joints?, Trying to locate a washer between ball joint and strut |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| astronomerdave |
 Feb 7 2009, 06:35 PM
Post
#1
|
|
Member  Group: Members Posts: 69 Joined: 26-January 09 From: Los Angeles, CA Member No.: 9,979 Region Association: Southern California  |
I'm replacing the ball joints on my '72 4 cyl. The original BJs had a washer on top, between the BJ and the strut. I ordered a new set from Pelican (901-341-049-00-M69) but it didn't come with any washer, nor is there one listed on their site. If you look at their full catalog then there isn't even a washer shown in the diagram. However, my Haynes manual shows the washer I removed (and damaged upon removal), as item 41 in Fig.7.2.
So, where can I find this washer if it's not listed at Pelican? What if I didn't use it? The ID of the washer that was there just fit snugly around the post of the BJ, so it might be tough to find a non-specific replacement. Thanks, Dave |
   |
 
|
Posts in this topic
astronomerdave Washer for ball joints? Feb 7 2009, 06:35 PM
914Sixer As far as I remember it is just a common wave wash... Feb 7 2009, 08:08 PM
Cap'n Krusty
As far as I remember it is just a common wave was... Feb 7 2009, 09:39 PM craig downs Another one from So Cal :wttc: Feb 7 2009, 11:29 PM 914Sixer In book 4 of the factory manual on page 2.1-1.1 ha... Feb 8 2009, 07:57 AM astronomerdave Glenn Sager at Pelican checked the Porsche parts s... Feb 10 2009, 11:26 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st June 2024 - 08:14 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.