 A little worried |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| turnaround89 |
 Mar 3 2009, 02:46 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 671 Joined: 17-May 08 From: Rockford, Illinois Member No.: 9,067 Region Association: Upper MidWest  |
I was putting my dual carbs on my motor and setting up the linkage. Pulled the carbs off a couple time to get the linkage bar in bushing on each side of the carb plate. A little springs sits inside the bushing, however, when i pulled off one of the carbs the spring fell out and i have no idea where the thing went. I'm worried that the spring fell through the intakes and into the engine because i have looked everywhere in my garage. With my bad luck, this is probably what happened. What do i do? I need the spring, and don't want to start the motor with that spring sitting inside of it,if thats where it is, it would probably ruin something!!!!
|
   |
 
|
Posts in this topic
turnaround89 A little worried Mar 3 2009, 02:46 AM
Dave_Darling Magnet on a stick. Poke it down the carbs; if you... Mar 3 2009, 09:37 AM rhodyguy the throttle plates should have remained in the cl... Mar 3 2009, 09:44 AM turnaround89 The spring sits inside a plate that goes underneat... Mar 3 2009, 01:04 PM
Todd Enlund I'd think that if the engine is installed, the... Mar 3 2009, 01:18 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 8th June 2024 - 12:13 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.