 Won't Start after conector problem., No spark. Why? PLEASE HELP!!! |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| old9one4 |
 Apr 18 2009, 08:57 PM
Post
#1
|
|
Newbie  Group: Members Posts: 35 Joined: 1-March 07 From: Sunnyvale, CA Member No.: 7,574 Region Association: Northern California  |
72' car with 71' wiring (assembled in Dec 71') so no oil tempurature wire in ingition harness.
While searching for oil temp wire I didn't replace the ignition harness connector back on the relay board correctly. It was tilted at an angle with the #1 pin end possibly not contacted. Motor would not turn over. Fuel pump started but no cranking. Tried to jump thinking battery was low. With no help from jump I reviewed my previous actions. When I found the tipped connector I pushed it back down to the correct contact problem. Now motor turns over and fuel pump works but no start. Only thing I can think of is no spark but, don't know why. Any thought on this? Coil damaged or worse alternator damaged? |
   |
 
|
Posts in this topic
old9one4 Won't Start after conector problem. Apr 18 2009, 08:57 PM
jaxdream Oil temp wire should go down underneath to the oil... Apr 18 2009, 11:05 PM Jeffs9146 Check all of your fuses! Apr 19 2009, 09:42 AM Dave_Darling Verify that it's not getting spark.
If not, c... Apr 19 2009, 09:50 AM firstknight13 :D i had the same problem...turned out to be the v... Apr 20 2009, 09:49 PM
old9one4 Problem diagnosted. Missaligned connector on relay... Apr 20 2009, 09:52 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 03:57 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.