 Interesting obsevations of old cam and bearings, Pics of bearing wear |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| DNHunt |
 Feb 29 2004, 03:45 PM
Post
#1
|
|
914 Wizard? No way. I got too much to learn.  Group: Members Posts: 4,099 Joined: 21-April 03 From: Gig Harbor, WA Member No.: 598  |
Kevin, Gerry and I split the case of a core motor I have. I have no info on mileage or previous work. All bearings were stamped standard so I suspect it was the first time apart. We found a small nick in the cam and the corresponding bearing was scored. Also one half of the front bearing was showing copper. There appeared to be a little wear on the case near the rear seal.
Dave Attached image(s) 
|
   |
 
|
Posts in this topic
DNHunt Interesting obsevations of old cam and bearings Feb 29 2004, 03:45 PM
DNHunt Here's a little wear on the cam lobes Feb 29 2004, 03:46 PM crash914 Hey!, I just pulled mine apart today also...lo... Feb 29 2004, 05:20 PM ChrisReale That cam wear is exactly what you usually find whe... Feb 29 2004, 05:49 PM rhodyguy save some dough dave. stick it back in the new eng... Feb 29 2004, 06:11 PM crash914 my cam bearing pictures... Mar 4 2004, 06:27 AM crash914 my cam picture Mar 4 2004, 06:28 AM crash914 my lifters.... Mar 4 2004, 06:28 AM 2-OH! Dave:
Take it over to NWCR and Jerry will exchang... Mar 4 2004, 08:18 AM Bleyseng I think Dave is going to use this case for his 227... Mar 4 2004, 08:21 AM Mark Henry Although the cam doesn’t “look” too bad, I w... Mar 4 2004, 08:25 AM 415PB Ditch the cam. Save the cam gear. Instead of dri... Mar 4 2004, 08:30 AM Jake Raby That bearing is not "In the copper" It is an OEM K... Mar 4 2004, 09:02 AM Mark Henry Jakes right...if that thrust cam bearing is within... Mar 4 2004, 09:15 AM Jake Raby I do the same! Mar 4 2004, 10:01 AM rhodyguy i was kidding about the cam ;) a used cam and lift... Mar 4 2004, 10:14 AM
crash914 Yea, I am going with all new parts..I just wanted ... Mar 4 2004, 10:46 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd June 2024 - 07:21 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.