 Shifts into 1st only when rolling |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| zeezee |
 Jul 20 2009, 10:54 PM
Post
#1
|
|
Member  Group: Members Posts: 115 Joined: 16-October 08 From: san ramon, ca Member No.: 9,651 Region Association: Northern California  |
9 out of 10 times I cannot shift into 1st when fully stopped without a fight.
Shifting into first works fine when I'm still moving... but then I have to sit at lights with the clutch pushed in. It's the same cold or hot. Shift linkage shifts well otherwise. No grinding. Cones and bushings are tight - checked and rechecked. Clutch gets fully engaged. Running 85/140 with required GL5 goo. Other gears sync fine at a stand still. I recently replaced the whole 1st gear syncro assembly - is there some magic adjustment I could have missed? |
   |
 
|
Posts in this topic
zeezee Shifts into 1st only when rolling Jul 20 2009, 10:54 PM
96740 That's funny. I can only shift into 1st when s... Jul 20 2009, 11:03 PM markb Try shifting into 2nd, then into 1st while stopped... Jul 20 2009, 11:16 PM
zeezee
Try shifting into 2nd, then into 1st while stoppe... Jul 20 2009, 11:26 PM
tat2dphreak
Try shifting into 2nd, then into 1st while stopp... Jul 21 2009, 07:45 AM dw914er
Try shifting into 2nd, then into 1st while stoppe... Jul 20 2009, 11:38 PM PRS914-6 You shouldn't have to comply with some "s... Jul 21 2009, 12:09 AM zeezee
You shouldn't have to comply with some ... Jul 21 2009, 12:32 AM Dr Evil If your slider has teeth at all this should not ha... Jul 21 2009, 01:36 AM zeezee
If your slider has teeth at all this should not h... Jul 21 2009, 03:40 PM Dr Evil Just checked other thread:
Those slider teeth are ... Jul 21 2009, 01:37 AM ellisor3 I have been haing a lot of shifting issues as well... Jul 21 2009, 07:14 AM Dr Evil When you install the slider that way you set the w... Jul 21 2009, 03:55 PM zeezee Thanks for all the feedback!
I'll look at ... Jul 21 2009, 04:34 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 31st May 2024 - 10:35 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.