 Reinstalling emerg brake handle, what comes first? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| EJP914 |
 May 17 2010, 08:12 PM
Post
#1
|
|
Member  Group: Members Posts: 260 Joined: 14-June 03 From: Monroeville, PA Member No.: 821  |
Finally getting around to putting the e-brake handle back on. New rear calipers were installed. What is the sequence for reinstalling?
1. Secure the handle to the side wall inside? 2. Try to pull the cables in far enough to attach to the swivel at the end of the cable? OR is the reverse of this? I tried to hook up the cables and then pull the handle to the front to its pivot peg, but it goes no where. I never looked under the car at the firewall, but are there any "adjusters" under there that will slacken the cable to allow the handle to go back on? I thought I read somewhere sometime there are adjuster nuts near where the cable enter the firewall? Thanks for the help. |
   |
 
|
Posts in this topic
EJP914 Reinstalling emerg brake handle May 17 2010, 08:12 PM
dlee6204 I'm not sure of the order off hand but you can... May 17 2010, 09:25 PM McMark You need to put the cables from the rear calipers ... May 17 2010, 10:21 PM
EJP914 Many thanks to McMark to dlee6204 for the informat... May 18 2010, 05:38 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 17th May 2024 - 08:32 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.