 flux core welder |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| RonnieJ |
 Sep 6 2010, 02:45 PM
Post
#1
|
|
RonnieJ  Group: Members Posts: 230 Joined: 16-June 03 From: Sterling Heights, Michigan Member No.: 829 Region Association: Upper MidWest  |
I need to do some work in the hell hole and only have a flux core welder. I'll be using lincoln wire and 18 guage to make a patch and I bought a new engine shelf for that side.
|
   |
 
|
Posts in this topic
RonnieJ flux core welder Sep 6 2010, 02:45 PM
9146986 You have to chip the slag off the welds before you... Sep 6 2010, 04:23 PM RonnieJ Yea I know but I flux core is all I have so I gues... Sep 6 2010, 05:00 PM realred914 gas shielded will be MUCH better if you can, get a... Sep 6 2010, 05:01 PM RonnieJ I just found a place close by that I can rent a ga... Sep 6 2010, 05:11 PM
realred914
I just found a place close by that I can rent a g... Sep 6 2010, 07:16 PM kg6dxn It will be cheaper in the long run for you to conv... Sep 6 2010, 06:18 PM TargaToy With flux core I think .030" wire is the smal... Sep 6 2010, 07:42 PM Vacca Rabite For what its worth, I did nearly all the welding o... Sep 6 2010, 08:22 PM draganc I would rather upgrade your flux core welder for t... Sep 6 2010, 08:36 PM plays with cars ditto... I did the hell hole repair work on my ca... Sep 6 2010, 09:27 PM Root_Werks Already mentioned, yes, I believe .30 is the small... Sep 7 2010, 08:48 AM realred914
Already mentioned, yes, I believe .30 is the smal... Sep 7 2010, 09:13 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 18th May 2024 - 07:18 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.