 Anyone have a mill?, looking for carb covers |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| r_towle |
 Apr 22 2011, 07:55 AM
Post
#1
|
|
Custom Member  Group: Members Posts: 24,585 Joined: 9-January 03 From: Taxachusetts Member No.: 124 Region Association: North East States 
 |
I am looking for two cover plates for 40MM IDF carbs.
Simple flat aluminum, 1/2 inch thick, with two holes that will accept IDA (not IDF) velocity stacks. So, its needs to be the right shape for the IDF. It would need two holes for the velocity stacks. It would need a funky hole for the emulsion tubes I would like to have the outer edge camfered at a 45 degree angle so the horizontal face is 50% of the total thickness. I need two for dual carbs. |
   |
 
|
Posts in this topic
r_towle Anyone have a mill? Apr 22 2011, 07:55 AM
gms
I am looking for two cover plates for 40MM IDF ca... Apr 22 2011, 11:24 AM RJMII I have my mll, but not sure if it is big enough fo... Apr 22 2011, 11:58 AM Gint :bump: I'd go for a set too. Apr 22 2011, 07:10 PM McMark I used these ones and loved them. Can't recal... Apr 22 2011, 08:18 PM McMark AHA! I knew I had pictures... Apr 22 2011, 08:23 PM
r_towle
AHA! I knew I had pictures...
Those are hot... Apr 22 2011, 08:53 PM PRS914-6 Easier to mark them, center punch the holes and bo... Apr 22 2011, 08:26 PM Randal
I am looking for two cover plates for 40MM IDF ca... Apr 22 2011, 08:31 PM sixnotfour Thanks Glenn, mine were for tripples Apr 28 2011, 06:18 PM gms
Thanks Glenn, mine were for tripples
Jeff,
I was... Apr 28 2011, 08:21 PM Smitty911 I have a small CNC Mill at home. What's the l... Apr 28 2011, 11:15 PM r_towle
I have a small CNC Mill at home. What's the ... Apr 29 2011, 07:47 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 30th May 2024 - 11:20 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.