 gearshift stop plate, dimension question |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| luskesq |
 May 12 2011, 09:11 AM
Post
#1
|
|
Member  Group: Members Posts: 276 Joined: 24-October 10 From: Fresno, CA Member No.: 12,303 Region Association: Central California  |
In replacing all of the bushings, ball cup, shift balls and spring guides on my '70 tailshifter, I noticed alot of wear in the stop plate. I want to rebuild it and need the dimension of the slot in the stop plate (the spring loaded plate inside the shifter) that the gearshift rod rides inside of that is shaped somewhat like an old fashioned keyhole. Don't need the size of the circle or the length of the slot but really need the width because that I would think would affect the amount of throw. Much appreciated.
Keith |
   |
 
|
Posts in this topic
luskesq gearshift stop plate May 12 2011, 09:11 AM
McMark 15.25mm by my measurement. May 12 2011, 09:57 AM
luskesq
15.25mm by my measurement.
Boy, I really appreci... May 12 2011, 10:45 AM Cap'n Krusty Put some weld in there, restore the damaged side t... May 12 2011, 10:54 AM kkid I have just replaced with new one and did not see ... May 12 2011, 12:11 PM luskesq Thank you both Cap'n & KKid. I did as you... May 12 2011, 01:33 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 19th May 2024 - 03:13 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.