 push rod tube seals |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| ruddyboys |
 Jul 20 2004, 12:22 PM
Post
#1
|
|
Hummel eigentümer  Group: Members Posts: 594 Joined: 3-March 04 From: Monroe, NY Member No.: 1,749 Region Association: North East States  |
My old pushrod tube "O" rings were very loose fitting on the head size (red) the block side were tight. Picked up a new set from the Bird and the fit the same, loose at the head end. When I tried to install them the ring would pull out and curl under the lip. Why? I have the old set, should I try the black ones on top too. '70 1.7 now 2056
|
   |
 
|
Posts in this topic
ruddyboys push rod tube seals Jul 20 2004, 12:22 PM
Cap'n Krusty I you have early pushrod tubes and later heads, th... Jul 20 2004, 02:15 PM Jake Raby yep, capn is right. The early 1.7 had 1mm smaller ... Jul 20 2004, 03:02 PM Toast If you have alunimum push rod tubes, they are prob... Jul 20 2004, 03:03 PM ruddyboys What is a good Teflon sealant, does it come in a t... Jul 20 2004, 03:07 PM Dave_Darling 
newdeal2 Speaking of the seals and Pelican... I just got on... Jul 20 2004, 05:18 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 3rd May 2024 - 09:54 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.