 Help mounting Clutch/pressure plate |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Bill Meyer |
 Sep 29 2011, 03:15 PM
Post
#1
|
|
Newbie  Group: Members Posts: 44 Joined: 11-October 07 From: Prairie Village, KS Member No.: 8,210  |
I'm bolting down this pressure plate here and something doesn't seem right. As you can see the bolt face goes into the recess on the flywheel. It doesn't hit, but your socket starts slipping since it starts hitting the flywheel. I suppose I can tighten it down carefully with a wrench, but I don't remember this issue when taking it off the old motor.
Confused??... Attached image(s) 
|
   |
 
|
Posts in this topic
Bill Meyer Help mounting Clutch/pressure plate Sep 29 2011, 03:15 PM
underthetire Yep, been there. Get your flywheel machined recent... Sep 29 2011, 03:22 PM proto31 Use allen bolts, make sure that they are 10.9 hard... Sep 29 2011, 03:25 PM
Bill Meyer As a matter of fact it was machined, that explains... Sep 29 2011, 03:44 PM Mike D. I have a hardened 13mm for impact wrench that ... Sep 29 2011, 04:32 PM 76-914
I have a hardened 13mm for impact wrench that ... Sep 29 2011, 04:38 PM Mike D.
I have a hardened 13mm for impact wrench that ... Sep 29 2011, 04:43 PM Cap'n Krusty If it's that deep, I certainly wouldn't us... Sep 29 2011, 05:12 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 25th May 2024 - 05:57 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.