 stuck cyl/head stud, Any suggestions ? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| MrHyde |
 Mar 4 2012, 11:23 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 525 Joined: 13-October 10 From: Ontario, Canada Member No.: 12,268 Region Association: None  |
Ive been taking out the studs on the engine case today so I can send it to the machine shop to have the cylinder registers squared up, but I'm stuck on 2 studs... I've soaked them in pb blaster off and on for days and I've tried a little bit of heat on them with an MPS torch. Not a lot of heat because i don't want to f up the case. Any hints on getting these 2 studs out ??
Thanks, Mike Attached thumbnail(s) 
|
   |
 
|
Posts in this topic
MrHyde stuck cyl/head stud Mar 4 2012, 11:23 AM
mepstein Have the machine shop do it. Mar 4 2012, 11:34 AM 6freak some one put "RED" loctite on them Mothe... Mar 4 2012, 11:45 AM 914Mels Try more heat. Also a mix of acetone and automatic... Mar 4 2012, 11:52 AM jimkelly isn't the block magnesium - once on fire - har... Mar 4 2012, 12:03 PM
mrbubblehead
isn't the block magnesium - once on fire - ha... Mar 4 2012, 12:14 PM bulitt Some local autoparts stores will lend you tools. ... Mar 4 2012, 04:25 PM 6freak
Some local autoparts stores will lend you tools. ... Mar 6 2012, 08:43 AM MrHyde Well.. I thinks I'll focus more on my cutting/... Mar 4 2012, 09:04 PM 6freak so your at a died end and i hate F n hammers...if ... Mar 4 2012, 11:06 PM Mark Henry They can be a bitch but I've never had one bre... Mar 6 2012, 11:42 AM McMark You're not going to overheat the case with any... Mar 6 2012, 12:01 PM 6freak heat the case not the stud ...jmo then use that c... Mar 6 2012, 03:06 PM 6freak any luck getting them studs out :confused: Mar 10 2012, 03:14 PM MrHyde I'm gonna let the machine shop take care of it... Mar 10 2012, 04:17 PM 6freak
I'm gonna let the machine shop take care of i... Mar 10 2012, 04:59 PM Vacca Rabite When I had a stuck stud the dude used a torch on t... Mar 10 2012, 05:56 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th May 2024 - 06:37 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.