 Engine Lid Hinge Repair |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| cary |
 Nov 28 2012, 09:49 PM
Post
#1
|
|
Advanced Member  Group: Members Posts: 3,900 Joined: 26-January 04 From: Sherwood Oregon Member No.: 1,608 Region Association: Pacific Northwest 
 |
Taking a time out on my rustoration project.
Decided to tackle my problem with the engine lid hinge on my other car. Late last summer I found the hinge was coming away from the body. Hinge wasn't cracked. Spot welds were still intact. The damn firewall had cracked. Right above the top spot welds. (IMG:style_emoticons/default/sad.gif) (IMG:style_emoticons/default/sad.gif)   |
   |
 
|
Posts in this topic
cary Engine Lid Hinge Repair Nov 28 2012, 09:49 PM
cary The extra hole was a feeble attempt at tightening ... Nov 28 2012, 10:01 PM partwerks Ridges would probably be to stiffen up the sheet m... Nov 28 2012, 11:09 PM aharder J West has the set up :D
http://www.jwesteng.com... Nov 29 2012, 06:17 AM zambezi I see a trunk hinge setup but i don't see anyt... Nov 29 2012, 07:27 AM jimkelly i don't think the engine lid brackets go bad v... Nov 29 2012, 07:40 AM
SirAndy i don't think the engine lid brackets go bad v... Nov 29 2012, 02:34 PM Jgilliam914
i don't think the engine lid brackets go bad ... Nov 29 2012, 06:12 PM cary I think we'll attach the patch on top to tie i... Nov 29 2012, 09:56 AM 9146986 If you overlay the metal it would push the engine ... Nov 29 2012, 01:00 PM mr914 Where is it common to crack?
I'm having an al... Nov 29 2012, 04:15 PM cary
Have you tried a Blair Rotabroach? They make th... Nov 29 2012, 08:25 PM cary Just thought I would add a little note.
Here... Nov 29 2012, 08:36 PM cary Getting ready to weld on the patch.
Prepped loc... Nov 29 2012, 08:40 PM cary Aligning the patch and holding it with my Big Ass ... Nov 29 2012, 08:43 PM cary Tacked in, ready to check alignment.
Nov 29 2012, 08:45 PM cary Here's it installed and covered with self etch... Nov 29 2012, 08:56 PM cary But bad news. I found a little rust under the rear... Nov 29 2012, 09:02 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 24th May 2024 - 12:58 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.