 Bolt application, Question |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Randal |
 Jan 31 2013, 02:29 PM
Post
#1
|
|
Advanced Member  Group: Members Posts: 4,446 Joined: 29-May 03 From: Los Altos, CA Member No.: 750  |
I've been looking for a button head cap screw that I could use with Gotti 3 piece wheels. The screw has to able to take 14 foot pounds of torque (168 inch pounds), so the normal versions you can find break. By switching to socket head cap screws the torque issue.s goes away, but socket heads have a higher profile than I would like. I know the Gotti folks sell, for about a buck apiece, the button heads that will take the torque, but would like to find a US supplier. Need M6 x 35mm. |
   |
 
|
Posts in this topic
Randal Bolt application Jan 31 2013, 02:29 PM
McMark My unenducated research says that a M6 bolt that c... Jan 31 2013, 03:10 PM
Randal
My unenducated research says that a M6 bolt that ... Jan 31 2013, 03:28 PM
Randal
My unenducated research says that a M6 bolt that ... Feb 5 2013, 01:36 PM underthetire have you tried
http://www.mrmetric.com/metric-fast... Jan 31 2013, 03:44 PM Harpo Because of the federal Fastener Act all fasteners ... Jan 31 2013, 04:33 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 25th May 2024 - 12:45 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.