GROUP BUY: 5-LUG CONVERSION - Drilled 914 front rotors and rear hubs, PMB Performance Options

[billh1963]

1970 through 1972.8 - Early 914 Package P/N 914.351.352.01
Retail = $720.40
Discount = $144.08
Group Buy Total = $576.32

Commitments:
1. Gene
2. Eyesright
3. Igo914

1972.8 through 1976 - Late 914 Package P/N 914.351.352.02 (Centering Ring will be machined off the front rotors)
Retail = $772.40
Discount = $154.48
Group Buy Total = $617.92

Commitments:
1. billh1963
2. billh1963
3. Chris H.
4. Philip W.
5. Darin300
6. Nie Zu Alt
7. KENNY
8. MrLeeS

This Group Buy will need to have 10 or more participants to get the pricing where we need it. The price includes the following items:

(2) Front Rotors (early or late) machined to 5x130 with studs included.
(2) Sets of bearings and seals for above.
(2) Rear rotors machined to 5x130.
(2) Machined Hubs (you must supply the cores) freshly plated in silver zinc with studs included.
(2) Rear wheel bearings.

To be a part of this group buy you must send in a pair of rear hubs. The machining costs are based upon a minimum of 10 pair of rear hubs and ten pair of front rotors.

***IMPORTANT*** Once the group buy reaches the minimum on the hubs and rotors we can talk about pricing on separate units ('hey... how much for a pair of rear hubs only?" -or- "how much for an extra pair of front rotors?") GROUP BUY ENDS 3/3/2013 (we will extend it through the All Porsche Swap Meet and Car Show in Anaheim)

So.... going 5-lug for $6-clams with all new components and new bearings ta boot?!?!? Yeah... it's a good deal. If you look at the rotor pricing alone, this is just $22 - $24 more per rotor over the stock pricing but it includes the machining and studs! On the rear hubs the savings is around $30.00...

Again, this is a complete soup to nuts 914 5-lug package. Bearings, seals rotors, hubs and studs. It's all there ready for you to bolt it on. These will be screw in studs with Red Loctite as seen below.

Picture of a late model front rotor with the centering ring machined off and the 5x130 pattern machined into the hub section
(IMG:http://www.914world.com/bbs2/uploads/post-1110-1284690383_thumb.jpg)

It shouldn't be too hard to find 10 people in this big ole world of ours who want this at the best price possible. Commit now and be cruising in style this summer...