 Homemade solid tranny mount..., Had some time to kill.... |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Mike D. |
 May 26 2003, 03:30 PM
Post
#1
|
|
OK, It runs now, and pretty good too!  Group: Members Posts: 1,445 Joined: 3-January 03 From: Santa Clarita, Ca Member No.: 85 Region Association: None 
 |
What do you think of these? I made them from a big hunk of billit aluminum. Center hole is same thickness as a stock tranny mount. Anybody want to take bets on dragging the transmission on the ground? Just kidding, I'm not sure if I trust myself. I guess I could install them then drive around a bit and see if anything is cracking...
-Mike D. Attached image(s) 
|
   |
 
|
Posts in this topic
Mike D. Homemade solid tranny mount... May 26 2003, 03:30 PM
Mike D. no. 2 May 26 2003, 03:31 PM Mueller They look similar to the units HPH sells, nothing ... May 26 2003, 04:05 PM LvSteveH :clap: May 26 2003, 04:24 PM Aaron Cox looks good! how much did the materials cost? ;... May 26 2003, 04:37 PM Mike D. Thanks for the feed back. guess I'm on the rig... May 26 2003, 07:22 PM Mueller You can buy scrap from recyclers for a few bucks p... May 26 2003, 08:10 PM
914Timo QUOTE
  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th April 2024 - 03:43 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.