 Caliper Question - Calling Eric, 914/4 vs. 914/6 rear |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| bigkensteele |
 Dec 30 2013, 09:53 PM
Post
#1
|
|
Major Member  Group: Members Posts: 2,197 Joined: 30-August 04 From: Cincinnati, OH Member No.: 2,660 Region Association: South East States 
 |
I understand that the piston diameter is larger on the six caliper, but externally, they appear to be very similar if not identical.
My question is why can't a rear four caliper be bored to the same piston diameter as the six? Not enough meat on the bone? Mind you, I understand that if it could be done, PMB probably would not have gone through the trouble to create the GT caliper. Just being curious here. |
   |
 
|
Posts in this topic
bigkensteele Caliper Question - Calling Eric Dec 30 2013, 09:53 PM
Steve It's not just the piston, the pads are also sl... Dec 30 2013, 10:22 PM mr914 There is also a difference in the casting
The 4s ... Dec 31 2013, 06:05 PM
Eric_Shea Piston - You would need 2.5mm off the edge of the ... Dec 31 2013, 06:15 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 19th May 2024 - 09:54 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.