 Pushrod tube "pop", Seating the tubes |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| ericoneal |
 May 15 2014, 08:45 PM
Post
#1
|
|
Member  Group: Members Posts: 320 Joined: 13-August 12 From: Crestwood, KY Member No.: 14,795 Region Association: South East States  |
I pushed like hell to get the tubes in, but they never "popped" into place like many on here describe. They seem to be tight although they will flex back and forth laterally some if I push and pull on them. Is this normal, or should they be completely immovable?
SHould the outer lip of the tube be flush or inset in the head? They did 'POP' on the way out... |
   |
 
|
Posts in this topic
ericoneal Pushrod tube "pop" May 15 2014, 08:45 PM
stugray The slight pop you feel is the o-ring going over t... May 15 2014, 10:53 PM Cap'n Krusty In over 40 years of doing pushrod tube reseals, I... May 15 2014, 11:15 PM ericoneal Thanks guys.
I bought the Viton seals this time ... May 16 2014, 06:32 AM stugray Note: When installing the springs, there is a righ... May 16 2014, 07:24 AM Elliot Cannon Retainer springs? :rotfl: :poke: May 16 2014, 07:27 AM stugray
Or you can just glue them in with a full tube of... May 16 2014, 07:55 AM
Elliot Cannon
Or you can just glue them in with a full tube o... May 16 2014, 06:28 PM ericoneal Glad I rechecked these again tonight, they were no... May 16 2014, 08:27 PM Dave_Darling I've even turned a screwdriver around and used... May 16 2014, 08:56 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 9th May 2025 - 04:07 AM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.