 Glad I don't work on these cars for a living, A couple of "Ah Sh*t"s |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| DNHunt |
 Jan 16 2005, 08:03 AM
Post
#1
|
|
914 Wizard? No way. I got too much to learn.  Group: Members Posts: 4,099 Joined: 21-April 03 From: Gig Harbor, WA Member No.: 598  |
I dropped the new engine out of my car again yesterday. I had to take care of a couple of problems. I'll take advantage of this to check the valves, retorque and swap 1st gear stuff in my other tranny then install it. I kept thinking I had a pushrod tube leaking but I got under the car with the engine warm. By the way don't touch anything Ouch!
This is what I found. Sllow leak from the case through bolt. This might be a bitch. Attached image(s) 
|
   |
 
|
Posts in this topic
DNHunt Glad I don't work on these cars for a living Jan 16 2005, 08:03 AM
DNHunt This one is easier. I installed new output shaft s... Jan 16 2005, 08:06 AM davep Tranny seals are supposed to be flush to the case.... Jan 16 2005, 09:17 AM Mark Henry Did you use the ARP case bolts?
Yep, it's goi... Jan 16 2005, 09:44 AM Bleyseng What did you use as a thread locker and sealant? M... Jan 16 2005, 10:07 AM rhodyguy shit. bummer.
kevin Jan 16 2005, 10:14 AM DNHunt Leak at Through bolt fixed. I removed the head to ... Jan 16 2005, 01:17 PM
DJsRepS If your OEM Tstat and cable and pully are removed ... Jan 17 2005, 04:48 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 18th May 2024 - 02:51 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.