 Rust repair recommendations, What minimal repairs can I do now? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| SA-914 |
 Aug 10 2014, 05:39 PM
Post
#1
|
|
Member  Group: Members Posts: 125 Joined: 30-June 14 From: San Antonio,tx Member No.: 17,566 Region Association: Southwest Region  |
I recently purchased a 73 2.0 with Dual Webers, 40 IDF. I runs really well. It does have some rust. I've included some pictures. My quandry is that I would like to do some repairs now, but not tackle the hell hole until winter. I would like to enjoy the car for a bit before pulling the engine and tackling the engine compartment. I was going to just cut off the jack plates now, and clean up the area. I cannot find any rust other that the jacks on the longs. inside, I would like to cut out and repair the back panel. The back has some pin hole higher up and is rusted in the lower passenger corner.
My question, is this feasible? Can I do these repairs from the inside? I would like to atleast make the interior water tight and then battle the engine compartment later. |
   |
 
|
Posts in this topic
SA-914 Rust repair recommendations Aug 10 2014, 05:39 PM
SA-914 I recently purchased a 73 2.0 with Dual Webers, 40... Aug 10 2014, 05:40 PM SA-914 My apologies for the triple post. Aug 10 2014, 05:45 PM PanelBilly I'm not seeing anything that looks too bad. Wh... Aug 10 2014, 05:54 PM Mike Bellis :wttc:
It can be fixed... Aug 10 2014, 06:01 PM 914Sixer SA-914 I am up in Boerne if you have questions. F... Aug 10 2014, 09:33 PM SA-914 I've attached another picture. I pulled the f... Aug 11 2014, 06:17 PM 76-914 That upper piece is a snap. That lower piece is no... Aug 12 2014, 07:33 AM ned911 Let me know if you find a 914 knowledgeable body p... Aug 12 2014, 08:36 AM
SA-914 I'm going to tackle the body stuff myself. I ... Aug 12 2014, 01:39 PM SA-914 The cutting begins. Easily cut through the fire w... Aug 14 2014, 07:47 AM 914Sixer SA-914, I have a 74 body setting in the back yard.... Aug 14 2014, 08:56 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 23rd May 2024 - 11:27 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.