 getting under the heat shield..., how the heck do you get in there? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| barebrad |
 Sep 21 2014, 05:05 PM
Post
#1
|
|
Member  Group: Members Posts: 54 Joined: 13-September 13 From: Huntsville, Al Member No.: 16,382 Region Association: South East States  |
Alright folks, I've been cleaning, grinding and sand blasting all day. I'm trying trying to figure out how to get under the heat shield? Do you cut it out? Just leave it alone? (I'm to OCD to do that!) I'm thinking about cutting it out and weld in some studs and I can bolt it in after paint. What do most do?
Thanks |
   |
 
|
  |
Replies
| Mike Bellis |
Sep 21 2014, 05:13 PM
Post
#2
|
|
Resident Electrician Group: Members Posts: 8,345 Joined: 22-June 09 From: Midlothian TX Member No.: 10,496 Region Association: None 
|
You would have to cut it out. A tab on each side and a spot weld in the middle.
|
|
|
|
Posts in this topic
barebrad getting under the heat shield... Sep 21 2014, 05:05 PM
barefoot there are 6 tabs with 2 spot welds each if you can... Sep 21 2014, 06:58 PM
SirAndy there are 6 tabs with 2 spot welds each if you can... Sep 22 2014, 09:56 AM
barebrad Are the spot welds in the bottom of the trunk? If ... Sep 22 2014, 12:41 PM SirAndy I saw no screws
Only the factory /6 cars and very ... Sep 22 2014, 01:09 PM scotty b
I saw no screws
Only the factory /6 cars and very... Sep 22 2014, 01:13 PM Johny Blackstain
Only the factory /6 cars and very early /4 cars h... Sep 22 2014, 01:13 PM malcolm2
there are 6 tabs with 2 spot welds each if you ca... Sep 22 2014, 12:56 PM barefoot
[quote name='barefoot' post='2088826... Sep 22 2014, 05:30 PM worn
Alright folks, I've been cleaning, grinding a... Sep 21 2014, 06:58 PM RobW Out of sight... Out of mind? Sep 22 2014, 11:08 AM Spoke I removed the heat shield initially to do some tru... Sep 25 2014, 05:00 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 22nd May 2024 - 10:05 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.