 Time to start laying out the cooling system |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| quadracerx |
 May 3 2015, 05:04 PM
Post
#1
|
|
Member  Group: Members Posts: 426 Joined: 3-July 06 From: WA Member No.: 6,366 Region Association: Pacific Northwest  |
Ok...
So parts will be here this week to finally put the mock up engine in the car for the first time.... So time to start planning the cooling system... I want to use aluminum hard lines in the longs, I'm thinking 1.25 or 1.5 OD. I will make a removable "bottom" on each of the longs one side for aluminum cooling lines and the other for braided stainless AN Fuel Lines. So here are my initial questions: 1).Should I buy and aluminum radiator with or without a cap? If I go without I will use either an inline fill in the upper hose? Or radiator cap where the thermostat housing original was on the Small Block Chevrolet? 2) Should I buy the aluminum radiator with outlets one on each side? OR both outlets on drivers or passenger side? 3) I am using an electric remote water pump, so I could mount it in either the engine bay or front trunk? 4) Which would be easier to use 1.25 or 1.5" OD Aluminum tubing for the cooling lines? Thanks guys I look forward to your responses... Steve |
   |
 
|
Posts in this topic
quadracerx Time to start laying out the cooling system May 3 2015, 05:04 PM
v82go Hi
I use 1" aluminum conduit on both of my ... May 3 2015, 05:19 PM
pdlightning
Hi
I use 1" aluminum conduit on both of my... May 3 2015, 10:36 PM quadracerx The plan is to cut open the bottom or side of the ... May 4 2015, 12:07 PM Andyrew The longs are structural, I highly suggest NOT doi... May 4 2015, 12:23 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 20th May 2024 - 08:18 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.