 temp sensor |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| last337 |
 Jun 29 2015, 06:58 AM
Post
#1
|
|
Member  Group: Members Posts: 421 Joined: 4-December 12 From: New Orleans Member No.: 15,221 Region Association: None  |
Does anyone know where the temp sensor wire connects to? I cant seem to trace it down in the wiring chart. The hard coating came off but I still have the underlying wire with the spade connection at the end just cant recall where it connects.
|
   |
 
|
Posts in this topic
last337 temp sensor Jun 29 2015, 06:58 AM
BeatNavy I can only speak to D-Jet. I assume you're ta... Jun 29 2015, 07:23 AM last337 Its a '73 2.0 with dual carbs. I am referring... Jun 29 2015, 07:37 AM
BeatNavy
Its a '73 2.0 with dual carbs. I am referrin... Jun 29 2015, 07:39 AM type47 Sounds like you're talking about the wire to t... Jun 29 2015, 07:43 AM last337
Sounds like you're talking about the wire to ... Jun 29 2015, 07:46 AM BeatNavy I'm particularly good at answering the wrong q... Jun 29 2015, 07:48 AM type47 No, I was confused too since there are 3 temp sens... Jun 29 2015, 07:50 AM last337 Now if I could only get the taco plate to stop lea... Jun 29 2015, 08:01 AM Dave_Darling The grommet doesn't make a seal, if I recall c... Jun 29 2015, 09:16 AM last337 That crush washer on sender, can I get just that w... Jun 29 2015, 09:59 AM type47
... can I get just that washer ...
I did a brie... Jun 29 2015, 10:09 AM last337 Cut a gasket too.
Cut a gasket? Isnt there some... Jun 29 2015, 10:13 AM type47
Isnt there somewhere that there are printable pa... Jun 29 2015, 10:38 AM last337
Isnt there somewhere that there are printable p... Jun 29 2015, 10:40 AM type47 Yes. But 'til you find it, here's a teaser... Jun 29 2015, 10:15 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 17th May 2024 - 07:34 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.