 Speedometer Drive Seal, Haynes shows an o-ring |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Allan |
 Mar 10 2005, 12:33 PM
Post
#1
|
|
Teenerless Weenie  Group: Members Posts: 8,373 Joined: 5-July 04 From: Western Mesopotamia Member No.: 2,304 Region Association: Southern California  |
I bought a speedo drive seal from GPR last week and it looks like the shifter seal only smaller. The haynes manual shows an 0-ring. Does anyone know which is correct before I try to replace it. The part number I have for the new one from GPR is 999.113.036.50.
Here is a crappy pic. Attached image(s) 
|
   |
 
|
Posts in this topic
Headrage Speedometer Drive Seal Mar 10 2005, 12:33 PM
Headrage http://www.914world.com/bbs2/ht... Mar 10 2005, 06:24 PM phantom914 There are two seals: an O-ring that seals the driv... Mar 10 2005, 06:31 PM phantom914 O.K. The O-ring part number is 999.701.084.50
Pel... Mar 10 2005, 08:35 PM trekkor I don't remember any seal but the o-ring on th... Mar 10 2005, 09:09 PM Headrage Maybe it goes in here? Mar 10 2005, 09:11 PM phantom914 Yes. The seal you showed goes there. Unthread the ... Mar 10 2005, 09:30 PM swood Mine seems to be a bit loose at that point. Could... Mar 10 2005, 10:17 PM Bruce Allert OK, so... if those 2 seals are replaced will it st... Mar 22 2005, 11:36 PM
Headrage What I saw when I pulled it apart was that you can... Mar 23 2005, 06:57 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 18th May 2024 - 08:33 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.