 Tins under push rod tubes |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Amphicar770 |
 Mar 23 2016, 01:41 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,191 Joined: 20-April 10 From: PA, USA Member No.: 11,639 Region Association: MidAtlantic Region 
 |
Hi All,
Should be putting in the new push rod tubes tomorrow and am planning to blast / refinish the tins that sit under them (or above depending on how you are looking). Normally I would powder coat them but since these sit so close to the cylinders I am wondering if they get too hot. Maybe just engine enamel? Thanks, Mike |
   |
 
|
Posts in this topic
Amphicar770 Tins under push rod tubes Mar 23 2016, 01:41 PM
The Cabinetmaker Not a powder coat guru, but I would think it would... Mar 23 2016, 01:51 PM euro911 Powder-coat or paint with 500° or higher paint an... Mar 23 2016, 01:55 PM McMark I powdercoat them. Mar 23 2016, 05:32 PM
Geezer914 Rust O leum grill paint good for 1200'. Mar 25 2016, 07:20 AM boxsterfan
Rust O leum grill paint good for 1200'.
:a... Mar 25 2016, 09:30 AM Amphicar770
Rust O leum grill paint good for 1200'.
:... Mar 25 2016, 09:34 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 19th May 2024 - 09:01 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.