1972 914 Options

[Zimmy]

1972 Porsche 914 1.7L 4cyl. Extensive mechanical restoration. Hell hole area clean and floors in good shape. Great project for restoration or drive as is. I can e-mail pictures upon request. Price: $8500
michael_zimmerman5@sympatico.ca

- rebuilt engine bottom end including new bearings for rods, crankshaft, and cam
- drilled and pipe plugged oil galleries
- new oil seals
- thermostat cable
- cylinders, pistons and rings 96mm (1910cc)
-proper compression ratio calculated and barrel shims installed
-cylinder heads rebuilt by Bill @motex (valve, guides, seats and valves)
- elephant feet valve adjusters
-all sheet metal media blasted and re-paint
-dual 40mm HPMX carb kit
-ignition wires, cap,rotor and plugs
- 3 oil changes, one after engine break in, one after first 100 kms and one before storage this past winter
-end play on crankshaft and flywheel set to spec
-flywheel and clutch assembly inspected,cleaned and reinstalled
-transmission overhauled with new seal/gasket kit -this is a side shift 5 speed
-1st and 2nd gear syncros replaced
-installed good used 1st reverse slider
-new synthetic oil
-new braided ground strap
-drive shafts and cv joints cleaned and inspected
-4 new cv joint boots and grease kits/clamps
-all new shifter bushings and boots
-gas tank removed/cleaned and painted with 2 stage paint
-new fuel lines and proper german clamps
- new fuel pump and filter
-cut out front steering rack support on right side of car and weld in a good used support I sourced from the USA. paint and undercoat
-sourced master cylinder/steering rack under tray from USA and paint, install with new hardware
- ATS rims blasted and repainted in 2 stage silver/clear
-new tires
-front and rear brake calipers/pistons and hardware cleaned, blasted and yellow zinc coated/black oxidecoated
-front and rear caliper rebuild kits with e-brake kits
-e-brake cables and pins
-front and rear brake pads
-turned and painted brake rotors, rotor hats painted in 2 stage paint
-repacked front bearings with new grease seals
-all new rigid brake lines including center tunnel line with fittings
-new master cylinder with rubber connector lines
-braided front and rear brake hoses
-media blasted spare tire rim and pain, installed good used spare tire, valve stem and balance
-new alternator and belt
-new stater motor
-new battery
-newer radio with cd player
-drive car and shake down, adjust and make sure everything works mechanically.