 Guess my cam!, Any suggestions. |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| toecutter |
 Apr 15 2005, 11:54 AM
Post
#1
|
|
Kid Close Enough  Group: Members Posts: 37 Joined: 6-March 05 From: Sherman, Texas Member No.: 3,723  |
Is there any way to figure out what kind of cam the PO installed without splitting the case? The reason I ask is since I need to clean/rebuild the carbs I want to make sure they are set up for the cam. Is there a trick or am I SOL? FYI this is a 2.0 with what I am told are 1.7 heads. The carbs are Weber 40 IDF's (not 44's). I have a Compufire and SS heat exchangers. It was running like a spotted ape until recently because of grunge getting into the carbs. The fuel filters looked like they had a little poop in them. I digress. I believe the PO bought the webers and put them on right out of the box. Just looking for some advice (as always).
|
   |
 
|
Posts in this topic
toecutter Guess my cam! Apr 15 2005, 11:54 AM
skline Nope, its a tear down in order to determine your c... Apr 15 2005, 11:56 AM MattR Cant you figure out valve lift without a teardown?... Apr 15 2005, 12:04 PM Dr. Roger Is your crank puley degreed and can you see it?
If... Apr 15 2005, 12:17 PM Aaron Cox i agree....
you can see (within a relatively clos... Apr 15 2005, 12:39 PM Mueller get a dial indicator and you can get a good idea o... Apr 15 2005, 12:42 PM bondo Have it dyno tuned.. if you make more power than s... Apr 15 2005, 12:55 PM ArtechnikA <... Apr 15 2005, 01:55 PM Aaron Cox http://www.914world.com/bbs2/h... Apr 15 2005, 05:20 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 19th May 2024 - 03:59 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.