Dads new car |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Dads new car |
mb911 |
Jun 9 2018, 09:16 AM
Post
#41
|
914 Guru Group: Members Posts: 6,854 Joined: 2-January 09 From: Burlington wi Member No.: 9,892 Region Association: Upper MidWest |
Attached thumbnail(s) |
Rob-O |
Jun 9 2018, 10:13 PM
Post
#42
|
Senior Member Group: Members Posts: 1,252 Joined: 5-December 03 From: Mansfield, TX Member No.: 1,419 Region Association: Southwest Region |
Nice! At least he’s making progress, even if it’s slow going.
Nice to see some folks stepping up and donating some parts. Kevin is a good guy, he sent me an enormous box of parts awhile back. Mark is stand up, too. Just from the photos I’ve seen I’ve got a few things I could send your way. I think I have a relay board cover and I know I definitely have a new front trunk seal. If you have a list send me a PM. I’ll gather what I have and get it to you. Just paying it forward... |
porschetub |
Jun 10 2018, 12:40 AM
Post
#43
|
Advanced Member Group: Members Posts: 4,701 Joined: 25-July 15 From: New Zealand Member No.: 18,995 Region Association: None |
Looks like a sound car,best to motor out as its a lot harder to free up otherwise.
Dump the oil and look for whitemetal and other bits you may find in the oil filter if you open it ,if that's ok the bottom end should be fine ,pull the motor and dose with a penetrant or what ever you want down the inlets...let it soak. I will mention what I did with a seized T4 1800 only months ago,flywheel was off so I found some meaty HT bolts and fitted them in the flywheel ,had previously put kerosene down the intakes cause that's all I had,heated the barrels with a heat gun,rocked it back and forward with a bar and it turned after a couple of repeat attempts,haven't stripped it right down yet but one good thing is it appears to have no valve issues. Good luck. |
ClayPerrine |
Jun 10 2018, 06:10 AM
Post
#44
|
Life's been good to me so far..... Group: Admin Posts: 15,474 Joined: 11-September 03 From: Hurst, TX. Member No.: 1,143 Region Association: NineFourteenerVille |
I saw in the picutres that the seat belt interlock relay is still connected. This will cause a no crank issue. There is a solid yellow wire and a yellow with a red tracer wire connected to them. Pull them from the relay and splice them together. That should fix the no crank issue.
And if you need anything, let me know. I probably have enough spare parts in my garage to build another 914 if I had a tub. |
Rob-O |
Jun 10 2018, 07:23 AM
Post
#45
|
Senior Member Group: Members Posts: 1,252 Joined: 5-December 03 From: Mansfield, TX Member No.: 1,419 Region Association: Southwest Region |
|
EdwardBlume |
Jun 10 2018, 07:59 AM
Post
#46
|
914 Wizard Group: Members Posts: 12,338 Joined: 2-January 03 From: SLO Member No.: 81 Region Association: Central California |
|
mb911 |
Jun 10 2018, 11:42 AM
Post
#47
|
914 Guru Group: Members Posts: 6,854 Joined: 2-January 09 From: Burlington wi Member No.: 9,892 Region Association: Upper MidWest |
Thanks everyone.. I will have dad make a list. I have been giving him any spares that I have and I know he would appreciate any help as he is on a very fixed income..
On his shortlist I know he wants to buy new ignition wires, cap, rotor for sure.. |
mb911 |
Jun 11 2018, 02:21 PM
Post
#48
|
914 Guru Group: Members Posts: 6,854 Joined: 2-January 09 From: Burlington wi Member No.: 9,892 Region Association: Upper MidWest |
Dad just sent me a list.. I messed up and gave away an engine lid. Oh well..
The List and pan Antenna fender mount Outside door handles and seals Trunk gasket Steering wheel and hub cover Gas tank strap and rubber cushion passenger side Driver's side mirror Window handles Front quarter windows with windowrails Front side marker light assemblies Hand brake- Handle assembly Trunk latch assembly Distributor cap Plug wires Brake hoses Rear brake pads Inner door panels Passenger window glass with mounting rail Engine lid assembly |
mepstein |
Jun 11 2018, 02:40 PM
Post
#49
|
914-6 GT in waiting Group: Members Posts: 19,279 Joined: 19-September 09 From: Landenberg, PA/Wilmington, DE Member No.: 10,825 Region Association: MidAtlantic Region |
The List and pan - ? Antenna fender mount - probably Outside door handles and seals Trunk gasket Steering wheel and hub cover - yes Gas tank strap and rubber cushion passenger side - yes Driver's side mirror - yes Window handles- yes Front quarter windows with windowrails - yes Front side marker light assemblies - yes Hand brake- Handle assembly - yes Trunk latch assembly - yes Distributor cap Plug wires Brake hoses Rear brake pads Inner door panels - yes, tan Passenger window glass with mounting rail Engine lid assembly- yes |
mb911 |
Jun 11 2018, 03:23 PM
Post
#50
|
914 Guru Group: Members Posts: 6,854 Joined: 2-January 09 From: Burlington wi Member No.: 9,892 Region Association: Upper MidWest |
The List and pan - ? Antenna fender mount - probably Outside door handles and seals Trunk gasket Steering wheel and hub cover - yes Gas tank strap and rubber cushion passenger side - yes Driver's side mirror - yes Window handles- yes Front quarter windows with windowrails - yes Front side marker light assemblies - yes Hand brake- Handle assembly - yes Trunk latch assembly - yes Distributor cap Plug wires Brake hoses Rear brake pads Inner door panels - yes, tan Passenger window glass with mounting rail Engine lid assembly- yes Mark, Clay is helping out with an engine lid., I found some door panels I will give him and 1 wart assembly , rear latch as well.. Making a smaller list. Yeah.. |
mepstein |
Jun 11 2018, 03:36 PM
Post
#51
|
914-6 GT in waiting Group: Members Posts: 19,279 Joined: 19-September 09 From: Landenberg, PA/Wilmington, DE Member No.: 10,825 Region Association: MidAtlantic Region |
The List and pan - ? Antenna fender mount - probably Outside door handles and seals Trunk gasket Steering wheel and hub cover - yes Gas tank strap and rubber cushion passenger side - yes Driver's side mirror - yes Window handles- yes Front quarter windows with windowrails - yes Front side marker light assemblies - yes Hand brake- Handle assembly - yes Trunk latch assembly - yes Distributor cap Plug wires Brake hoses Rear brake pads Inner door panels - yes, tan Passenger window glass with mounting rail Engine lid assembly- yes Mark, Clay is helping out with an engine lid., I found some door panels I will give him and 1 wart assembly , rear latch as well.. Making a smaller list. Yeah.. What’s the first thing on the list ? “And pan” |
mb911 |
Jun 11 2018, 03:48 PM
Post
#52
|
914 Guru Group: Members Posts: 6,854 Joined: 2-January 09 From: Burlington wi Member No.: 9,892 Region Association: Upper MidWest |
The List and pan - ? Antenna fender mount - probably Outside door handles and seals Trunk gasket Steering wheel and hub cover - yes Gas tank strap and rubber cushion passenger side - yes Driver's side mirror - yes Window handles- yes Front quarter windows with windowrails - yes Front side marker light assemblies - yes Hand brake- Handle assembly - yes Trunk latch assembly - yes Distributor cap Plug wires Brake hoses Rear brake pads Inner door panels - yes, tan Passenger window glass with mounting rail Engine lid assembly- yes Mark, Clay is helping out with an engine lid., I found some door panels I will give him and 1 wart assembly , rear latch as well.. Making a smaller list. Yeah.. What’s the first thing on the list ? “And pan” I am not sure it was in a text message from my step mom so not sure what that means. |
914Sixer |
Jun 11 2018, 04:14 PM
Post
#53
|
914 Guru Group: Members Posts: 8,886 Joined: 17-January 05 From: San Angelo Texas Member No.: 3,457 Region Association: Southwest Region |
I have the rear brake pads, Need shipping info.
|
mb911 |
Jun 11 2018, 04:22 PM
Post
#54
|
914 Guru Group: Members Posts: 6,854 Joined: 2-January 09 From: Burlington wi Member No.: 9,892 Region Association: Upper MidWest |
|
EdwardBlume |
Jun 11 2018, 07:39 PM
Post
#55
|
914 Wizard Group: Members Posts: 12,338 Joined: 2-January 03 From: SLO Member No.: 81 Region Association: Central California |
The List and pan - ? Antenna fender mount - probably Outside door handles and seals Trunk gasket Steering wheel and hub cover - yes Gas tank strap and rubber cushion passenger side - yes Driver's side mirror - yes Window handles- yes Front quarter windows with windowrails - yes Front side marker light assemblies - yes Hand brake- Handle assembly - yes Trunk latch assembly - yes Distributor cap Plug wires Brake hoses Rear brake pads Inner door panels - yes, tan Passenger window glass with mounting rail Engine lid assembly- yes I have (2) decent Right Side outer door handles that can be combined to make one good one, plus 2 new seal kits for the outer door handles. Is the trunk gasket front or rear? |
mb911 |
Jun 11 2018, 08:47 PM
Post
#56
|
914 Guru Group: Members Posts: 6,854 Joined: 2-January 09 From: Burlington wi Member No.: 9,892 Region Association: Upper MidWest |
The List and pan - ? Antenna fender mount - probably Outside door handles and seals Trunk gasket Steering wheel and hub cover - yes Gas tank strap and rubber cushion passenger side - yes Driver's side mirror - yes Window handles- yes Front quarter windows with windowrails - yes Front side marker light assemblies - yes Hand brake- Handle assembly - yes Trunk latch assembly - yes Distributor cap Plug wires Brake hoses Rear brake pads Inner door panels - yes, tan Passenger window glass with mounting rail Engine lid assembly- yes I have (2) decent Right Side outer door handles that can be combined to make one good one, plus 2 new seal kits for the outer door handles. Is the trunk gasket front or rear? Rear.. I gave him a semi decent front one.. |
ClayPerrine |
Jun 12 2018, 08:34 AM
Post
#57
|
Life's been good to me so far..... Group: Admin Posts: 15,474 Joined: 11-September 03 From: Hurst, TX. Member No.: 1,143 Region Association: NineFourteenerVille |
A silver engine lid has been shipped. It is going slow boat via parcel post. Otherwise it was going to be $200.00 to ship due to it being oversized.
Tracking #9461210200830953140314 Hope it helps him out! |
mb911 |
Jun 12 2018, 09:39 AM
Post
#58
|
914 Guru Group: Members Posts: 6,854 Joined: 2-January 09 From: Burlington wi Member No.: 9,892 Region Association: Upper MidWest |
A silver engine lid has been shipped. It is going slow boat via parcel post. Otherwise it was going to be $200.00 to ship due to it being oversized. Tracking #9461210200830953140314 Hope it helps him out! Thank you and completely understand slow boat is fine.. My dad operates at this level anyway. |
mb911 |
Jun 12 2018, 03:21 PM
Post
#59
|
914 Guru Group: Members Posts: 6,854 Joined: 2-January 09 From: Burlington wi Member No.: 9,892 Region Association: Upper MidWest |
Talked to dad today. He is excited and thankful for all the help.. He is a long time enthusiast. Over the years he had 3 356s, 2 912s, 2 914s, 1 924 turbo and countless British cars. Unfortunately he sold all of them before each became valuable except the last 356 which he was able to make some money on.. Not nearly enough for retirement after a divorce etc.
He is heading into the garage this afternoon to do some work. |
914forme |
Jun 12 2018, 05:51 PM
Post
#60
|
Times a wastin', get wrenchin'! Group: Members Posts: 3,896 Joined: 24-July 04 From: Dayton, Ohio Member No.: 2,388 Region Association: None |
Side window with rail - tinted or clear?
I might have what he needs in the hoard, ahh I mean parts awaiting future projects located in my shop. (IMG:style_emoticons/default/beer.gif) Presuming since it is a 74 nobody put an early door on that side. I probably have that one in the hoard (IMG:style_emoticons/default/headbang.gif) ahh valuable parts awaiting future projects pile. Still working on the proper wording to make the parts hoarding seem like less of an issue and more of a planned future, yeah that was a smart thing todo sort of thing. (IMG:style_emoticons/default/av-943.gif) |
Lo-Fi Version | Time is now: 21st May 2024 - 05:31 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |