 Heat resistant gasket on intake manifold ?, Do I really need one ? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| David Mueller |
  May 1 2005, 11:07 AM
Post
#1
|
|
Member  Group: Members Posts: 79 Joined: 4-February 03 From: Calgary, Alberta Canada Member No.: 236  |
I've a '74 with dual webbers and the PO had put thick heat resistant gasket between the intake runner and the head. My question is do I really need it ? It's about 3/16 thick and looks like asbestos impregnated material.
The local VW guy says it's to stop the head from heating up the lower section of the intake runner and says normally they run thin intake gaskets on either side of that heat sheild gasket anyway. Any opinions ? |
   |
 
|
Posts in this topic
David Mueller Heat resistant gasket on intake manifold ? May 1 2005, 11:07 AM
ArtechnikA yes, you need it. yes, you run gaskets on both si... May 1 2005, 11:13 AM David Mueller I'm having a hard time finding the thick gaske... May 1 2005, 11:19 AM rhodyguy i use the stock phelenolic(sp?) ones on the silver... May 1 2005, 11:34 AM ArtechnikA CB Performance would be where i'd start, or at... May 1 2005, 11:34 AM SirAndy or, just use the ones that came with your FI ...
... May 1 2005, 11:40 AM bondo Will these work?
Intake manifold gasket
They... May 1 2005, 11:42 AM David Mueller The CB performance units look like they go between... May 1 2005, 11:44 AM SirAndy they are the same bolt pattern and they will fit f... May 1 2005, 11:58 AM
Aaron Cox i got the phenolics for 8 bucks at Save a Bug Auto... May 1 2005, 12:16 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 22nd May 2024 - 04:51 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.