 rear Valance question |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Frankvw |
 Jul 20 2017, 01:11 AM
Post
#1
|
|
working on my first 914 !  Group: Members Posts: 651 Joined: 13-April 16 From: Holland, the Netherlands Member No.: 19,896 Region Association: Europe  |
Hi all, I went through the posts on valances, but did not find the answer (did learn a lot though so no time wasted)
I have a 73 1.7, the rear Valance under the backbumper has a cut-out as a notch to exit the tailpipe. I still have the old type mufller that has an exit in the middle, where endpipe is attached to, which ends through the rear Valance on the left side. The NOS endpipe I scored on Ebay (a 021 251 171 M), is shorter then the one that was on the car, so.....it does not reach the nothed out clearance of the Valance. I took off the rearvalance, and started looking around if there are valances that are suitable for this pipe (in the meantime also for another endpipe of course) Question : There are also rear valances with a hole cut out instead of a notch. Is the location of that hole the same as the notch in the other type rear valance ? Or is that located more to the center ? Thanks for your feedback. |
   |
 
|
Posts in this topic
Frankvw rear Valance question Jul 20 2017, 01:11 AM
BillC I did some quick internet searching, and it look l... Jul 20 2017, 06:33 AM maf914 The 70-71 four cylinder cars were equipped with a ... Jul 20 2017, 07:16 AM
Frankvw Thanks for your feedback. Maybe I do need a 'N... Jul 20 2017, 11:27 AM Tom_T
Thanks for your feedback. Maybe I do need a ... Jul 20 2017, 12:00 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 5th May 2024 - 11:10 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.