 Throttle cable routing, following "original" is it correct? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Calwaterbear |
 Dec 9 2017, 06:34 PM
Post
#1
|
|
Member  Group: Members Posts: 207 Joined: 15-November 14 From: United States Member No.: 18,123 Region Association: Central California  |
Ok so I'm replacing the throttle cable, when it comes out of the firewall, the previous owner has it routed up through a small hole on the right (passenger side) near the hell hole.
Can I assume that is correct? thanks |
   |
 
|
  |
Replies
| simonjb |
Dec 11 2017, 02:55 PM
Post
#2
|
|
KiwiMan Group: Members Posts: 563 Joined: 18-October 16 From: Stamford, Connecticut Member No.: 20,505 Region Association: North East States 
|
So the hole to the bottom left of the Coil?
 |
|
|
|
| ChrisFoley |
Dec 11 2017, 03:05 PM
Post
#3
|
|
I am Tangerine Racing Group: Members Posts: 7,933 Joined: 29-January 03 From: Bolton, CT Member No.: 209 Region Association: None
|
QUOTE(simonjb @ Dec 11 2017, 04:55 PM)  So the hole to the bottom left of the Coil? The stock location works for factory efi but not so well for carbs. Better to come up between the tin and engine shelf, and then maybe put a fresh hole in the tin once you see the most favorable routing. |
|
|
|
Posts in this topic
Calwaterbear Throttle cable routing Dec 9 2017, 06:34 PM
flmont I would think so plus should be secured along the ... Dec 9 2017, 09:25 PM 914Sixer Should be in a rubber grommet in the center of the... Dec 10 2017, 07:41 AM bdstone914
Ok so I'm replacing the throttle cable, when... Dec 10 2017, 09:00 AM simonjb Anyone have a picture? I have the same question Dec 11 2017, 11:58 AM Perry Kiehl The stock grommet is in the right engine tin, basi... Dec 11 2017, 02:27 PM simonjb ahh, ok - so through the tin attached to the engin... Dec 11 2017, 02:50 PM
SKL1 Agree with Chris if you have carbs. Too many shar... Dec 11 2017, 04:34 PM simonjb Great. Thanks Dec 11 2017, 06:31 PM
Perry Kiehl FWIW, I've always wanted to make a bell crank ... Dec 11 2017, 09:23 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 28th May 2024 - 12:01 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.