 Using POR-15 to Repair Holes, Anybody ever done this? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| vesnyder |
 Jun 9 2005, 05:57 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 680 Joined: 14-April 05 From: Cleveland, OH Member No.: 3,933  |
Repairing my floorboards I found that the floor under the drivers seat we worse than all the others? So bad that when I was poking around I poked a hole about the size of a golfball. (see pic) I am going to try to use POR-15 to fix and treat the hole before I consider welding in a new panel. If it works I figure it is a cheap alternative? Anybody ever done this?
Attached thumbnail(s) 
|
   |
 
|
Posts in this topic
vesnyder Using POR-15 to Repair Holes Jun 9 2005, 05:57 AM
AndyC Personally I would get out the grinder with a wire... Jun 9 2005, 06:02 AM xsboost90 weld first, then POR15. You don wanna fall out on ... Jun 9 2005, 06:11 AM Verruckt My floors only had a few holes that were visible. ... Jun 9 2005, 06:13 AM ablose58 http://www.914world.com/bbs2/html/e... Jun 9 2005, 06:14 AM joeav8tor rust is cancer, if left untreated your 914 will di... Jun 9 2005, 07:32 AM CptTripps http://www.914world.com/bbs2/h... Jun 9 2005, 07:41 AM
Mark Henry I've used the POR-15 and mat on a bug, but it ... Jun 9 2005, 09:08 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th May 2024 - 11:13 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.