 Can you weld new metal to Original engine mount |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| flmont |
 Sep 17 2018, 09:44 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 879 Joined: 21-October 08 From: Tucson,Az Member No.: 9,676 Region Association: Southwest Region 
 |
I need a stronger engine mount for my EG33 engine,I started to think about adding some steel to my Original ( 4 Cyl ) engine mount / cross bar and Iam curious if this could even be done,.?? Thanks Frank
|
   |
 
|
  |
Replies
| Mike Bellis |
Sep 17 2018, 09:57 PM
Post
#2
|
|
Resident Electrician Group: Members Posts: 8,345 Joined: 22-June 09 From: Midlothian TX Member No.: 10,496 Region Association: None 
|
I think it's cast iron. Not sure how well it would hold up.
Just buy some square tubing 0.120 wall. Weld a stack of washers at the ends and it will look almost like the stock bar. Then weld your brackets. Or build one of these...  |
|
|
|
Posts in this topic
flmont Can you weld new metal to Original engine mount Sep 17 2018, 09:44 PM
flmont well I had some 1/8 walled square tubing but when ... Sep 17 2018, 11:30 PM IronHillRestorations No bueno on welding to the later style cast bar, b... Sep 18 2018, 05:50 AM
theer
No bueno on welding to the later style cast bar, ... Sep 18 2018, 08:15 AM flmont Well Thank You Theer I appreciate it,I may take yo... Sep 18 2018, 05:53 PM flmont and Mike Bellis,..If I could build that I would b... Sep 18 2018, 05:56 PM Chi-town Welding plate or tube to cast takes a little fines... Sep 19 2018, 09:11 AM yeahmag I've had it done for tabs for an oil cooler (o... Sep 19 2018, 12:03 PM flmont Not Yet Chi-town,the small car brackets extend rig... Sep 19 2018, 07:40 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 18th May 2024 - 11:51 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.