 Floor Pan Opinions |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| sharper |
 Jul 14 2003, 05:49 PM
Post
#1
|
|
Member  Group: Members Posts: 146 Joined: 5-June 03 From: Woodstock, GA Member No.: 789 Region Association: South East States  |
I obviously have some rust issues with my floorpan and wanted to get some opions. Basically the entire section under the center tunnel is rusted out and a few other little areas as well. A friend suggested cutting out the rusted areas and then "sandwich" the new floorpan underneath the old. It is a whole lot less prepwork if I just cut out the entire floor and weld in the new. What is everyone's opion on this?
|
   |
 
|
Posts in this topic
sharper Floor Pan Opinions Jul 14 2003, 05:49 PM
Brad Roberts I can see his point...
but I wouldnt consider the... Jul 14 2003, 05:55 PM vsg914 Cut and weld!!! No "sandwich"!... Jul 14 2003, 05:58 PM Jeroen The 914 is "sandwiched" enough as it is... so plea... Jul 14 2003, 06:57 PM urbanskater hey i'm working on my floor pans right now. An... Jul 14 2003, 09:37 PM sharper That settles it. I am going to cut the whole thin... Jul 15 2003, 12:55 PM Brad Roberts Make damn sure you leave a 1/2 inch wide "lip" all... Jul 15 2003, 01:04 PM Alfred Have you seen this floor pan replacement video fr... Jul 15 2003, 05:36 PM Matt914MI I'm kind of in the same place right now...I... Jul 15 2003, 11:17 PM
Gint Do the whole pan. Even if you do get all of the r... Jul 16 2003, 08:18 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 17th May 2024 - 03:59 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.