 Screws on the tins..., Tricks? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Tjmrfe |
 Aug 19 2019, 11:53 AM
Post
#1
|
|
NON IMPEDING RATIONE COGITATIONIS  Group: Members Posts: 132 Joined: 10-April 15 From: Cornwall on Hudson, New York Member No.: 18,612 Region Association: North East States  |
Hey Gents,
In the “well this isn’t fun category” (IMG:style_emoticons/default/headbang.gif) I’m taking the tin’s off my 1.8... (Who’s bright idea was it to use flat head screws?) So far, the ones going into the block are frozen...Should I apply heat? On the exposed ones, a little nut buster and some heat they came right off, I’ve tried tapping with a hammer and a screwdriver, to no avail.... But, I’m apprehensive about using heat with ones that go into the block? Should I be? As always, thanks in advance... |
   |
 
|
Posts in this topic
Tjmrfe Screws on the tins... Aug 19 2019, 11:53 AM
mepstein I would use heat. It’s our go to at the shop. Th... Aug 19 2019, 11:57 AM
Tjmrfe
I would use heat. It’s our go to at the shop. T... Aug 19 2019, 11:59 AM Tdskip Ditto on heat, just had to do this, it helped. Aug 19 2019, 12:04 PM Tjmrfe
Ditto on heat, just had to do this, it helped.
... Aug 19 2019, 12:20 PM nditiz1 Like Mark said heat it. If not going for concours... Aug 19 2019, 12:04 PM Tjmrfe
Like Mark said heat it. If not going for concour... Aug 19 2019, 12:27 PM IronHillRestorations I use a hand impact on the tough ones. I have any... Aug 19 2019, 12:09 PM Mikey914 We sell the stainless ones if you need them. Aug 19 2019, 12:37 PM porschetub Heat yes,small butane torch,I undo the chewed out ... Aug 19 2019, 02:10 PM mepstein Don’t be afraid to get it HOT. We use MAP gas to... Aug 19 2019, 02:35 PM Mikey914 Also helps to have the LARGE standard screwdriver ... Aug 19 2019, 03:51 PM  |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 3rd May 2024 - 08:19 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.