 Frunk won't close, New Rubber is too 'proud', cannot squeeze it down enough |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| ctc911ctc |
 Jan 18 2020, 10:20 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 892 Joined: 9-June 18 From: boston Member No.: 22,206 Region Association: North East States 
 |
Hi,
I am replacing ALL of the rubber in our '74 2.0. All is going well though the TARGA pieces are a bear. In the frunk the seal that goes around the entire frunk will not allow the lid to close all the way without bending the lid!!!  Seems that it is too tall? The old rubber though beat up, fits and allows the lid to close fine.  I have a note into 914Rubber, but I thought I would ask the team here if this is a common problem?  THANK YOU ctc911CTC |
   |
 
|
  |
Replies
| Olympic 914 |
Feb 4 2020, 03:31 PM
Post
#2
|
|
Group: Members Posts: 1,665 Joined: 7-July 11 From: Pittsburgh PA Member No.: 13,287 Region Association: North East States
|
Right or Wrong, I am also in the "No Glue" camp.
At first it would rise up out of the trough, but over time it settled in place. I like the ability to remove and wipe under the seal. |
|
|
|
Posts in this topic
ctc911ctc Frunk won't close Jan 18 2020, 10:20 PM
Chris914n6 First off, the divider seal is backwards.
Does th... Jan 18 2020, 10:51 PM
ctc911ctc
First off, the divider seal is backwards.
Does t... Jan 20 2020, 02:26 PM ctc911ctc *************UPDATE***********
Turns out my son i... Feb 4 2020, 12:35 PM 914sgofast2 I was advised not to install them with any glue be... Feb 4 2020, 02:47 PM 914_7T3
I have a note into 914Rubber, but I thought I wo... Jan 19 2020, 12:28 AM Tdskip Door and trunk fit in general is a common issue wi... Jan 19 2020, 08:19 AM drem914 I had the same issue when I first replaced the sea... Jan 19 2020, 12:00 PM DRPHIL914
I had the same issue when I first replaced the se... Feb 4 2020, 03:19 PM bbrock IIRC, Mark said the way to tell the early and late... Jan 19 2020, 12:07 PM Mikey914 Correct.
The 1st ones we sold were A generic.
The ... Jan 19 2020, 02:52 PM Eric_Shea 3M weatherstrip adhesive. Follow the directions. ... Feb 4 2020, 02:49 PM bbrock
Right or Wrong, I am also in the "No Glue... Feb 4 2020, 03:53 PM ctc911ctc Great advice, thank you! Feb 4 2020, 05:12 PM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 14th May 2024 - 01:29 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.