 Tie-Rod Ball joint, How do you tighten them? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| frostyf |
 Nov 7 2020, 07:28 PM
Post
#1
|
|
Member  Group: Members Posts: 153 Joined: 27-March 14 From: VA 23455 Member No.: 17,168 Region Association: MidAtlantic Region 
 |
Hopefully someone with a bit more experience can give me a steer on this:
I've changed out my tie rods for turbo tie rods and have re-assembled them. Question is how do you tighten them to the required torque (manual says 33 ft lbs). The ball joint bolt spins as soon as any torque comes onto it (with either my electric hammer wrench or socket). There's no hex socket in the top to hold the ball-joint bolt whilst the nut is tightened? Is there some special way to fit them and tighten them to the correct torque? Thanks for any advice! Nick |
   |
 
|
Posts in this topic
frostyf Tie-Rod Ball joint Nov 7 2020, 07:28 PM
aharder I took my floor jack and applied pressure to them ... Nov 7 2020, 08:20 PM frostyf
I took my floor jack and applied pressure to them... Nov 7 2020, 08:40 PM porschetub
I took my floor jack and applied pressure to the... Nov 7 2020, 10:46 PM frostyf
[quote name='frostyf' post='2865108' date='Nov 8 ... Nov 9 2020, 06:48 AM frostyf
[quote name='frostyf' post='2865108' date='Nov 8... Nov 9 2020, 10:33 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 20th May 2024 - 10:26 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.