 Flywheel / crank end play, Did I do something wrong? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| adolimpio |
 Apr 7 2021, 05:10 PM
Post
#1
|
|
Art  Group: Members Posts: 180 Joined: 10-March 10 From: Greenwood SC Member No.: 11,449 Region Association: South East States 
 |
I finished building my engine, which uses a 2.0 crank in a 1.7 case.
My crank end play is 0.0125 without any shims. I've seen that you should use a minimum of 3 shims, but even a single smallest shim puts me at the edge of spec - 0.0125 - .00945 = 0.003. Is this OK? Did I do something wrong assembling? |
   |
 
|
  |
Replies
| 02loftsmoor |
Apr 8 2021, 08:47 PM
Post
#2
|
|
Senior Member Group: Members Posts: 577 Joined: 26-June 11 From: Ft. Worth TX Member No.: 13,243 Region Association: Southwest Region
|
I'm replacing the Flywheel .
i have Three .010" shims in, and i have .012" end play. what do i need to change?? |
|
|
|
Posts in this topic
adolimpio Flywheel / crank end play Apr 7 2021, 05:10 PM
Bleyseng Did you set the end play before installing the rea... Apr 7 2021, 08:23 PM adolimpio Yes, seal is not installed yet. Apr 7 2021, 09:19 PM adolimpio Problem solve, it was caused by the DACO.
I'm... Apr 8 2021, 04:35 PM
Mark Henry
I'm replacing the Flywheel .
i have Three .01... Apr 9 2021, 09:56 AM 02loftsmoor
I'm replacing the Flywheel .
i have Three .0... Apr 9 2021, 06:59 PM iankarr The shims are available in a range of sizes. You... Apr 8 2021, 09:02 PM 02loftsmoor
The shims are available in a range of sizes. You... Apr 8 2021, 09:19 PM iankarr Wow...just checked the type 4 store. You're ri... Apr 9 2021, 08:53 AM 02loftsmoor
Wow...just checked the type 4 store. You're r... Apr 11 2021, 08:24 AM Mark Henry When you get the shims be sure to test fit first. ... Apr 10 2021, 06:13 AM 02loftsmoor
When you get the shims be sure to test fit first.... Apr 11 2021, 08:18 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 6th May 2024 - 10:36 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.