 Throw out bearing installation question, shift fork cup bearing fit - how tight should it be on the ball? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| DRPHIL914 |
  Apr 20 2021, 07:14 AM
Post
#1
|
|
Dr. Phil  Group: Members Posts: 5,767 Joined: 9-December 09 From: Bluffton, SC Member No.: 11,106 Region Association: South East States 
 |
I guess my question is how tight should it be? it rides on the outside and it seems the ball should be all the way into the cut and fork, so it feels like i will have to force it onto this to get it to seat, is it ok to tap it with the rubber hammer to get it seated on the ball?
my transmission is back together and once this TO bearing and fork are installed its ready to go back into the car!!!! |
   |
 
|
Posts in this topic
DRPHIL914 Throw out bearing installation question Apr 20 2021, 07:14 AM
Mark Henry Tight but still a slip fit, make sure there's ... Apr 20 2021, 07:18 AM
DRPHIL914
Tight but still a slip fit, make sure there's... Apr 20 2021, 07:48 AM bdstone914
Tight but still a slip fit, make sure there... Apr 20 2021, 07:56 AM DRPHIL914
[quote name='DRPHIL914' post='2909456' date='Apr ... Apr 20 2021, 07:58 AM DRPHIL914 another question here- how loose should the shift ... Apr 20 2021, 08:23 PM IronHillRestorations A little wear on the fingers of the pressure plate... Apr 20 2021, 08:50 PM DRPHIL914
A little wear on the fingers of the pressure plat... Apr 20 2021, 08:58 PM wndsrfr
A little wear on the fingers of the pressure pla... Apr 21 2021, 07:47 PM DRPHIL914
[quote name='DRPHIL914' post='2909684' date='Apr ... Apr 23 2021, 09:39 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 24th May 2024 - 04:42 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.