 944 CV joints on 914 axle, A couple of questions |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| john77 |
 May 13 2021, 05:04 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 621 Joined: 21-February 14 From: Los Angeles Member No.: 17,027 Region Association: Southern California 
 |
I'm building a new set of these for my car. The old set on my car right now never had the 4mm machined off - it had one CV joint welded on and the other floating - so after reading through SirAndy's thread in the classics section I have a couple of questions.
[url](IMG:http://www.914world.com/bbs2/uploads_offsite/live.staticflickr.com-17027-1620947054.1.jpg)[/url] Do I use the washer that sits between the axle and the CV joint? (I'm guessing that's what it's for on the 944 axle... ) Is there a correct orientation for the CV joint - i.e. the line on the CV should be on the outside or inside - or doesn't it matter? And what's the best finish for axles, powdercoating? Any durable homebrew alternatives I can do myself? John |
   |
 
|
Posts in this topic
john77 944 CV joints on 914 axle May 13 2021, 05:04 PM
76-914 Yes. Notice that it is cupped. Concaved side towar... May 13 2021, 07:34 PM john77 Looks like I was originally reading an older thre... May 13 2021, 11:41 PM 76-914
Looks like I was originally reading an older thr... May 14 2021, 09:19 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 18th May 2024 - 09:00 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.