 Question on Connecting rod modificatiion, Wrist pin issue |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| finchmunoz |
 Jul 31 2022, 07:23 PM
Post
#1
|
|
Newbie  Group: Members Posts: 34 Joined: 3-July 11 From: Manila, Philippines Member No.: 13,272 Region Association: None  |
Any engine builder might help me with an advice…
I’m building my 78x96 engine and found an issue with the piston pin… my liner kit came with 24mm pins and the rods are 22mm. Can I have the rods opened up to 24mm? Will it be safe? (I’m using a c55 cam - 7k rpm maximum). The machinist will end up reaming the rods taking out 1mm to allow the pins to fit Your opinions will really help. TIA Attached thumbnail(s)  
|
   |
 
|
Posts in this topic
finchmunoz Question on Connecting rod modificatiion Jul 31 2022, 07:23 PM
Montreal914 You will actually need to bore out the connecting ... Jul 31 2022, 08:11 PM
finchmunoz
You will actually need to bore out the connecting... Jul 31 2022, 10:08 PM cgnj I have a few questions before I toss my opinion.
... Aug 1 2022, 01:48 AM ChrisFoley Didn't the machinist tell you altering the rod... Aug 1 2022, 04:53 AM 930cabman Find the correct pistons. I would not alter the ro... Aug 1 2022, 05:40 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 17th May 2024 - 10:22 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.