Door Panel Dimensions |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Door Panel Dimensions |
mmascari |
Jan 24 2023, 09:11 PM
Post
#1
|
Member Group: Members Posts: 321 Joined: 1-September 14 From: Concord, CA Member No.: 17,850 Region Association: None |
I picked up some door panels and need to cut holes for the door handle. Does anyone have dimensions from bottom/top and from the front of the panel to cut? Thank you
|
Mikey914 |
Jan 24 2023, 10:25 PM
Post
#2
|
The rubber man Group: Members Posts: 12,660 Joined: 27-December 04 From: Hillsboro, OR Member No.: 3,348 Region Association: None |
Should be able to flip over old panels and use as a template.
|
mmascari |
Jan 24 2023, 10:59 PM
Post
#3
|
Member Group: Members Posts: 321 Joined: 1-September 14 From: Concord, CA Member No.: 17,850 Region Association: None |
I was able to figure it out. I didn't have old panels but I just measured from the front and bottom of the door and just cut and checked until the holes were perfect.
|
dr914@autoatlanta.com |
Jan 25 2023, 11:22 AM
Post
#4
|
914 Guru Group: Members Posts: 7,850 Joined: 3-January 07 From: atlanta georgia Member No.: 7,418 Region Association: None |
early panels are smaller than the later ones: 8/69- about 8/72 were the smaller and 9/72-12/75 were the later ones
I picked up some door panels and need to cut holes for the door handle. Does anyone have dimensions from bottom/top and from the front of the panel to cut? Thank you |
jaredmcginness |
Jan 26 2023, 06:59 AM
Post
#5
|
... Group: Members Posts: 502 Joined: 12-June 19 From: Baltimore Member No.: 23,209 Region Association: MidAtlantic Region |
Here is my sketch from a few years ago for the panels I made for my early ('71) car.
Once foamed and lined they look great - but beware, I believe they were a tad off on some measurements. Unfortunately I cannot remember which. (P.S. this is only for the bottom portion, I drilled holes for the mounting tabs of the top cushion piece) also the length of the handle slot is 4.14" (IMG:http://www.914world.com/bbs2/uploads_offsite/i.imgur.com-23209-1674737987.1.jpg) |
Lo-Fi Version | Time is now: 13th May 2024 - 04:42 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |