 Rear Window, How to remove? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Mike's2nd914 |
 Aug 1 2003, 09:19 PM
Post
#1
|
|
Member  Group: Members Posts: 109 Joined: 26-April 03 From: Birmingham, AL Member No.: 616  |
My rear window dropped from the adhesive that was holding it in and has a nasty rattle. How do I remove it to replace the adhesive? It looks like the padding comes out from the top and the bottom just lifts out. Also, what do you recommend to replace the damaged adhesive?
|
   |
 
|
  |
Replies
| Jeffs9146 |
Aug 2 2003, 05:27 PM
Post
#2
|
|
Ski Bum Group: Members Posts: 4,062 Joined: 10-January 03 From: Discovery Bay, Ca Member No.: 128 |
Removing my rear window was twice as hard as any of you guys seem to have experienced. The bottom seal had a metal wire inside and the sealer that was used was hard as a rock. I managed to get a piece of cable through the top and pull it around the window edge until the window came loose. After cleaning and preping I used the same sealer used on the windshield and made sure it sealed in the corners known for leaking. Two people is highly recommended!
Jeff PS: make sure you have the new rubber trim seal in place! |
|
|
|
Posts in this topic
Mike's2nd914 Rear Window Aug 1 2003, 09:19 PM
Aaron Cox i think there is a tech article on it. i did mine ... Aug 1 2003, 09:30 PM Rob Ways You can take the old stuff off with leverage. Take... Aug 1 2003, 11:18 PM boxstr I have done about nine rear windows and after remo... Aug 1 2003, 11:29 PM tod914 I misplaced the directions so here it goes from me... Aug 2 2003, 08:26 AM vsg914 Once all the trim is removed, the window will come... Aug 2 2003, 04:31 PM Mike's2nd914 Good grief, can't anything be simple? Aug 3 2003, 10:12 AM Lawrence914-6 Actually, once you get in there, the job is fairly... Aug 3 2003, 06:36 PM
Dave_Darling I broke five wires trying to cut the seal on mine.... Aug 3 2003, 10:19 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 19th May 2024 - 04:01 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.