 Pushrod seals, Silicon??? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| BenNC |
 Aug 14 2003, 04:23 PM
Post
#1
|
|
Member  Group: Members Posts: 140 Joined: 7-February 03 From: Cary, NC Member No.: 267  |
When I replaced the o-rings on my pushrod tubes I noted that whoever had been in there previously had gooped the ends with silicon. The o-rings were pretty shot, so I thought that it was a cheap fix and got a chuckle out of it. Now I'm wondering if I should have added it.
Any thoughts? Thanks |
   |
 
|
Posts in this topic
BenNC Pushrod seals Aug 14 2003, 04:23 PM
MarkV You did the right thing. The seals are made to mov... Aug 14 2003, 04:29 PM airsix Like Mark said. The new viton (sp?) seals are ver... Aug 14 2003, 04:34 PM Brad Roberts I use a small brake cylinder hone and clean up the... Aug 14 2003, 05:03 PM Bleyseng I clean and touch up the sealing surface with #1 s... Aug 14 2003, 05:35 PM mr914 I clean my mating surfaces with a white scotchbrit... Aug 21 2003, 10:24 AM tat2dphreak ok, he did the right thing... but I think I screwe... Aug 21 2003, 02:10 PM Bleyseng Hopefully no RTV has entered the engine where it b... Aug 21 2003, 02:14 PM tat2dphreak I was careful about that when reassembling it... b... Aug 21 2003, 02:38 PM
mr914 I'd wait till it starts leaking in about 1000 ... Aug 27 2003, 09:58 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 10th May 2024 - 03:53 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.