 two questions, piston rings, where is the thread |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| toon1 |
 Jan 28 2006, 01:42 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,849 Joined: 29-October 05 From: tracy,ca Member No.: 5,022  |
I am going to install a new set of piston rings, will the standard ring compressors work on these motors?
I also want to flatten (lap?) the top of the cylinders. I have a peice of slate that I can use. I was thinking the best thing to do is use 1500 grit sand paper and do a wet sand but I remember a while back there was a thead about this. Can't seem to find the key word. Thank's guy's |
   |
 
|
Posts in this topic
toon1 two questions Jan 28 2006, 01:42 PM
r_towle Well, from what I recall.
Laping the cylinders...... Jan 28 2006, 03:45 PM KevinP I haven"t tried the clorox and tooth paste but, ye... Jan 28 2006, 03:50 PM Cap'n Krusty Only works IF you can hold the cylinder PERFECTLY ... Jan 28 2006, 04:51 PM toon1 I used a piece of granite tile and 1500grit wet sa... Jan 28 2006, 05:05 PM Joe Ricard Sounds like a good plan. as far as ring compressor... Jan 28 2006, 05:15 PM
toon1 Just doing the top end so the rods are in the case... Jan 28 2006, 05:26 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 28th May 2024 - 07:03 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.