 New clutch doesn't fit., Why, oh why!!! |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| LowGT |
 Feb 7 2006, 09:34 PM
Post
#1
|
|
1.8 and Proud!  Group: Members Posts: 583 Joined: 2-October 05 From: Wylie, TX Member No.: 4,904 Region Association: Southwest Region  |
Finally got the engine back together and I was putting the flywheel/clutch/pressure plate back on when... I tried to put the clutch disc into the flywheel and it's too big by about 2 mm. It's part number PCG-116-011-05 from pelican. The disc splines onto the tranny and clutch alignment tool fine, but too big for the flywheel.
Do I have a bus flywheel or something? |
   |
 
|
Posts in this topic
LowGT New clutch doesn't fit. Feb 7 2006, 09:34 PM
dmenche914 Got a measurement you can give us on the flywheel ... Feb 7 2006, 09:45 PM tat2dphreak http://www.914world.com/bbs... Feb 7 2006, 09:50 PM LowGT New clutch = 215.9mm
Old clutch = 209.55mm
Open... Feb 7 2006, 10:01 PM LowGT From the best I can tell, the marking on the back ... Feb 7 2006, 10:44 PM SirAndy Feb 7 2006, 11:31 PM LowGT Feb 7 2006, 11:50 PM SirAndy Feb 7 2006, 11:59 PM LowGT Interesting, I pulled my eng/trans because I was f... Feb 8 2006, 12:20 AM SirAndy Feb 8 2006, 12:24 AM Series9 Once upon a time, I had a 914 w/bus flywheel.
I d... Feb 8 2006, 12:37 AM LowGT Feb 8 2006, 01:09 AM
Tom Perso You have a 210mm Bus flywheel on your engine. I... Feb 8 2006, 06:55 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 18th May 2024 - 12:40 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.