 check out my crack |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| mightyohm |
  Nov 12 2003, 12:51 AM
Post
#1
|
|
Advanced Member  Group: Benefactors Posts: 2,277 Joined: 16-January 03 From: Seattle, WA Member No.: 162 Region Association: Pacific Northwest   |
Cylinder head crack that is.
Is this the fatal exhaust valve to port crack? Attached image(s) 
|
   |
 
|
Posts in this topic
jkeyzer check out my crack Nov 12 2003, 12:51 AM
jkeyzer closer Nov 12 2003, 12:52 AM jkeyzer the usual spark plug hole cracks. Nov 12 2003, 12:53 AM jkeyzer The other cylinder on this head has the same exhau... Nov 12 2003, 12:55 AM jkeyzer Head Nov 12 2003, 12:59 AM redshift I have had ones that appeared to be worse fixed, I... Nov 12 2003, 01:08 AM Brad Roberts Yep. I touched his crack. Hopefully The Jakester w... Nov 12 2003, 02:06 AM john rogers I had much worse on my stroker motor and they were... Nov 12 2003, 08:13 AM Red-Beard I know Motorwerks can do it in San Diego, but then... Nov 12 2003, 08:16 AM skline I had a set that was way worse than those. The PO ... Nov 12 2003, 08:19 AM jkeyzer I'm hoping Jake will comment too. I know that... Nov 12 2003, 10:35 AM Britain Smith I am going to the guy at the machine shop in San J... Nov 12 2003, 11:53 AM jkeyzer I don't have dimensions, but as you can see it... Nov 12 2003, 12:38 PM Britain Smith I just talked with Jay...the machine shop in San J... Nov 12 2003, 01:46 PM jkeyzer Britain - That sounds good. I'd like to have ... Nov 12 2003, 03:15 PM Britain Smith I will go down there to pick up some stuff on Frid... Nov 12 2003, 03:23 PM Brad Roberts Keyzer,
I may want to lump your heads in with the... Nov 12 2003, 03:34 PM Britain Smith And they can all get done within a reasonable time... Nov 12 2003, 03:43 PM anthony Brad, when are the heads going to the machine shop... Nov 12 2003, 08:22 PM Brad Roberts I have two more engines to pull apart this weekend... Nov 13 2003, 01:01 AM
r_towle This one seemed to need a pic to go along with the... Nov 13 2003, 10:14 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 20th May 2024 - 06:01 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.